The use of Setting up a Brick Paver Walkway or Lead Bricks or Pavers to produce a walkway or patio complements a house in a way that is unrivaled. It adds a level of quality and elegance to a house entrance that can not be accomplished with either concrete or asphalt. Brick and Pavers also can be found in many various colors and shapes permitting unique color plans and patterns to be achieved. In addition, installing a Brick or Paver sidewalk does not always need a pro. With some fundamental understanding and a relatively simple pathway strategy, a homeowner can undertaking such a project.
The key to setting up a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be installed. The location ought to be removed at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines must be strung on each side of the walkway. The string lines suggest the finished height of the sidewalk.
Once the area has been dug, 3/4" gravel stone should be laid in and tamped down tightly. 2" of sand, or stone dust need to be spread out over the gravel. Once again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline ought to equate to the density of the brick or paver.
Now that you have a steady base, place a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level surface location to lay the bricks/pavers.
Now put on the level sand/stone dust strips of plastic brick borders. Install an operate on both sides of the prepared area. These strips will act as your walkway border and aid to maintain the integrity and shape of the pathway. You can get these plastic strip borders read more at a lot of house enhancement shops. The strips need to be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.
As soon as this is done, you can then start to lay the bricks/pavers. There are lots of patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the integrity of the walkway.
Undoubtedly bricks/pavers will need to be cut or divided when constructing the walkway. To really cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you desire to break the brick. If your walkway has curves you will need to buy/rent a wetsaw.
After installing the bricks, develop the outdoors edges with extra sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the new pathway and sweep into the cracks. This will finish the interlocking of the bricks and assist to eliminate any weed growth.
In addition, installing a Brick website or Paver pathway does not necessarily require a pro. The secret to setting up a Brick or Paver Walkway is to very first appropriately prepare the location where the bricks/pavers are to be installed. Now that you have a stable base, place a 1" pipe or journal board the length of the walkway on either side of the sidewalk. These strips will act as your pathway border and help to keep the integrity and shape of the walkway. Undoubtedly bricks/pavers will need to be cut or split when developing the pathway.